|
|
|
Kto jest w sklepie?
Sklep przegląda 5460 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
(3) Set the QV-700 on �PLAY� mode and make sure that the picture taken is not too dark or too light. (4) After the shot, flash is charged automatically. Observing the ammeter, make sure that the charging current is less than 1.2 [A]. If the following pictures are taken, it may be caused by faulty wirings.
Shrinken
To solve this problem, install the wires as shown below.
Red wire White wire
1-5.Current consumption
(1) Set the QV-700 in �REC� mode. After the flash circuit is fully charged, make sure that the current consumption is less than 550 [mA] (for example, at PLAY mode, current consumption is 380 [mA] when the flash is fully charged. (2) Reduce the power supply voltage to 3.8 [V] and make sure that the low battery warning indicator is shown.
1-6.Clock reset
Perform the following procedures when you replaced PCB K772-DA. (1) Set the QV-700 in �REC� mode. (2) Execute the test program. � Set the dial on � �. � While holding down the �SHUTTER� and �DELETE� buttons, turn the POWER on. � While TEST MODE is indicated on the LCD, select the dial on Press �MENU� and � LCD indicates; � buttons simultaneously. .
CLOCK RESET STROBE ADJUST DEFECT CORRECT BATTERY CHECK �7�
|
|
|
> |
|
